Recent content by CornPopper

It appears the solution for now is to close the aap and relaunch the app in between flights, or while hovering, as I described.

So sorry. Should have searched much more. (most threads I'd skimmed seemed to be of folks who didn't follow the directions after the initial firmware update to sign onto the app). This thread describes my issue to a T: New iOS app 3.1.15

I beg to differ. I've been flying 3.1.15 since 8/27 and am still experiencing the issue intermittently. the work around (of closing the app (iOS) and relaunching), solves the issue, as it did before, but it's still happening to me. I've found it does not happen every time I do a battery...

Been getting an intermittent "Max Altitude/Distance Reached" message when flying. I've signed onto the site with my app, and have flown successfully many times. However, sometimes I'll get the warning message, and cannot exceed the limits set when not signed onto the app. I've discovered if I...

2 Questions: Is that the "T" connector I see rather than the magnetic mount as described on the website? Is this for the P4P or P3P?

Exposure to Air? Seriously?!? What am I supposed to do with new, yet to be used props, keep them in a vacuum?

go opposite direction, away from the cell tower, and see if you get a much different result. I'd expect you would.

Installed the HDMI module a month ago. No issues as described above. Works flawlessly.

Had the issue GF described. Installed the sggested pads. Problem resolved. Thanks GF! Took 15 min, but gimbal wouldn't rotate freely. Needed to move the bearing down a smidge, as described above. All good now. Total time: 25 min.

I've been flying these now for about a month. HDMI exclusively, with my P3A. Installed some cheater lenses to help my old eyes, and am using a better battery (OEM battery shipped with unit ........well, you know). For this purpose, in my setup, I'm pleased. A much more enjoyable experience...

3200' if you know where it is at. Less if you need to search the sky for it.

Unless you have an HDMI out from your Phone/Tablet.....

Yes. HDMI from controller to goggles on a P3A or P3P with the DJI HDMI Output Module upgrade installed on the controller.

The primary reason I was leaning toward the SR I mentioned above was the combo of ND and CP. I noticed that all suggestions cover ND, but not CP. Am I over emphasizing the need and value of CP in my quest? As I look at some of the multi lens kits, I imagine having to choose between the...

Was thinking of purchasing a single, quality lens filter for my P3A to be used in most daylight landscape conditions. Thought this would be best. Any other suggestions...