Recent content by adelaar

I've been having this issue for over a month now.. The GoPro boots up fine when I'm holding it, but once I connect it to the Phantom it keeps shutting down.. The GoPro was connected to the PC with a usb cable for over 8 hours so the battery is full. I have to remove the battery a few times...

I dropped the FPV on the floor, now one of the antenna sockets is broken. I'm wondering if it's possible to replace this part? Or to solder it? ( 1 pin is also broken from the socket ) Any help would be welcome! Thanks

Thank you for the replies! Since it's a dense area, i'm planning on using the GPS but going very high! is going high good against building interference? Thanks!

Hi, We need to film a particular building in the centre of Ghent. There's many buildings and churches close to it. So i'm wondering if there's extra precautions we can take? Not fly on GPS? is ATTI mode safe for interference from buildings/wifi/ ..? Thank you!

The footage of the waves splashing on the rocks is amazing!

A short video after the second snowfall in Belgium. It's not much but it's something! There's one mistake where you see the phantom in the shadow.. Was hard to avoid offcourse, also the first flight without GPS https://www.youtube.com/watch?v=AhF9wf5m-00

Hi, I've had this problem a couple of times.. Here's my sequence - Turn on controller - Turn on GoPro - Turn on Phantom What happens is 2 seconds later the gopro turns off, I power the phantom off, I try to boot the gopro but nothing is happening I thought the phantom charges the gopro, do i...

Hi, I recently bought the new Zenmuse Gimball ( got a crash with the previous one ) I see that they included a new anti-interference board, but you need 2x 8 Pin cable for it to work, the second one is not included. Any idea where I might find a spare cable? Can't really find one on dealers...

Thank you! Manual mode is not on. And i only started panicking after i saw that i lost complete control.. So still not sure what do the next time this happens..

What would failsafe do in a case where the GPS stops working? Information about flyaway: The battery was full ( around 80% ). There was a construction site which i flew close over, after that it just took a direction and went FULL speed in that direction. Didn't even have time to realise what...

Thank you for your answer, I use the homelock function sometimes but i'm talking about an Flyaway modus here.. I lost all control of the drone.. Was flying in GPS mode. My question is what my best reaction would be? I'm guessing since the drone is freaking out in GPS mode the homelock function...

Hi. I know there's tons of discussion about flyaways and how to avoid them. I recently had one where the drone was to far to see what direction is the front and a flyaway occured ( might be due to the fact i was in an area with a lot of houses ) I got in panic and tried to switch to atti but...

Could it be due to the fact ( in both crashed ) that I was close to buildings.. the first time i was above an underground parking as it seems the second time on my roof i was flying around 10m - 20m above the buildings.. Maybe it was to close? I'm still trying to figure out how this all...

Hi, I recently had a crash with my phantom, The internal parts seem okay, i removed the gimbal and the fat shark module to try and test it Everything seems to be working, The only thing is when it's running on idle the engines slowly start to increase power until it tries to go up.. The sticks...