Hi all,
Just finished my Yaw mod
allllll goooood
1st soldered the switch with resistors & wire, the resistance on both resistors was 9.86, happy with that.
Then soldered the switch to the TX. Drilled hole and installed.
I fitted my switch in the middle of both stick, personal preference
then fitted some stickers just to remind me what is On/Off.
Calibrated the TX in the RC System Assistant, then again in the Phantom Assistants.
Tested my new setup, phantom on desk with no props on. Fired it up, all working as it should.
Powered the unit down then tried to fire it up again with Yaw switch on, would not start. So all working as it should.
Only thing I did notice when I yaw to the right it did seem a bit faster they yaw to the left
This was a dummy run inside my house with no probs on not an actual flight. Test both resistors again, both were 9.86.
Need to take my Phantom for a proper test flight but if one way is slower I'll be happy with that.
I would just like to say a big thank you to J Dot for all his help & for sharing with us his mods
Top bloke in my eyes