Hi,
So based on the sticky gear thread, I'm going to buy:
This Transmitter: http://www.hobbyking.com/hobbyking/stor ... itter.html
$32.48
This Receiver: http://www.goodluckbuy.com/5-8g-7inch-8 ... raphy.html
$88.85
This iOSD: http://www.amazon.com/DJI-iOSD-Mini-Rea ... B00FKZZQQS
66.77
This connector cord: http://www.dpcav.com/xcart/Video-Cable- ... xtech.html
$9.99
And this mounting bracket: http://www.amazon.com/Hobbypower-Monito ... N0QN76BAJB
$5.19
For a total of $203.28 before shipping.
So does all that look good? Will it work well together? Can I hook everything up without having to solder anything? I should only have to open the top of the phantom 2 to connect the cable into the board, and then run it down and out the leg into everything else, correct?
Thank you for your help!
So based on the sticky gear thread, I'm going to buy:
This Transmitter: http://www.hobbyking.com/hobbyking/stor ... itter.html
$32.48
This Receiver: http://www.goodluckbuy.com/5-8g-7inch-8 ... raphy.html
$88.85
This iOSD: http://www.amazon.com/DJI-iOSD-Mini-Rea ... B00FKZZQQS
66.77
This connector cord: http://www.dpcav.com/xcart/Video-Cable- ... xtech.html
$9.99
And this mounting bracket: http://www.amazon.com/Hobbypower-Monito ... N0QN76BAJB
$5.19
For a total of $203.28 before shipping.
So does all that look good? Will it work well together? Can I hook everything up without having to solder anything? I should only have to open the top of the phantom 2 to connect the cable into the board, and then run it down and out the leg into everything else, correct?
Thank you for your help!