ribbon cable replacement

As suggested in another thread post here where you can get Part 49 the flat flexible data ribbon cable for the PRO/ADV P3. eBay: DJI Phantom 3 Pro Adv Flexible Gimbal Flat Ribbon Flex Cable Part 49 dual layer | eBay DJI Phantom 3 Pro Adv Flexible Gimbal Flat Ribbon Flex Cable Part I have used...

Hello All, While doing an antenna upgrade to my Phantom 3 controller, I damaged the ribbon cable that connects the main board to the USB board on the back. I could NOT find a replacement cable ANYWHERE! Apparently, DJI does not sell this part. After a long time searching, I found a local...

Hello All, While doing an antenna upgrade to my Phantom 3 controller, I damaged the ribbon cable that connects the main board to the USB board on the back. I could NOT find a replacement cable ANYWHERE! Apparently, DJI does not sell this part. After a long time searching, I found a local...

Hello All, While doing an antenna upgrade to my Phantom 3 controller, I damaged the ribbon cable that connects the main board to the USB board on the back. I could NOT find a replacement cable ANYWHERE! Apparently, DJI does not sell this part. After a long time searching, I found a local...

Do you guys have any good video links for changing ribbon cable and yaw arm. Thanks in advance.

Hello all, Recently discovered right joystick and RTH button mounts had failed internally - I Took apart, and upon opening the case the main/con ribbon popped loose from main board before I unlocked it. This seemed to weaken the ribbon connector's ability to lock the cable down. After...

Tips, tricks and small trade secrets to repairing your own camera .... Steps to repair a damaged camera for all Phantom 3 types | Jogjasky

Hi there I just had a mishap with my P3S when it flew into branches and crashed to the ground. Long story short, the camera and camera mount are now detached from the drone and the wire and mount are severed. I've attached photos below. At this point, I've figured out that I need a new yaw arm...

Hi, I read a lot of threads here about the P3 flat "con board / main board" ribbon cable. It's a very sensible cable that you can damage when your open or the RC or manipulate it with a pliers. I damaged mine when I installed the DBS mod (topic here : iPad not recognized after DBS itelite mod)...

I actually revised this thread I made since the earlier one was already irrelevant. The problem I raised was already solved and here's an update to my gimbal motor overload problem. I will share this here since I do not know how to delete this thread.