flips

  1. K

    P4 Flips after motor, shell replacement

    Crashed and got an ESC error. Opened shell to replace and discovered main board to esc ribbon cable loose. Had to also install one new motor. After repair, first flight hovered several seconds then flipped upside down. Calibrated IMUs, compass, and now it flips almost immediately. Triple check...
  2. ScottSr1950

    Advanced Blow Over Landings

    I've done around 15 flights with my P3A. I've landed on grass, hard surface etc. Even with no wind I am getting a blow over. I purchased the skid extension and thought that should take care of the problem but no luck. It is almost like the bird idles to fast when both sticks are pulled down and...
  3. B

    DJI FC40 Flip

    I have recently replaced the main board because of an issue with the 5V regulator. All ESC's have been soldered in the same manner in which the original unit was. The motors spin up (test and active flight) without fault. The problem begins when I begin to take off. I will apply two thirds...
  4. Signals

    A Successful Calibration does not always mean a Good Calibration

    raryrokni, in the DJI forum verified that the Phantom 3 would tend to flip over if you land and then try to take off again after idling your motors (not killing them). see this thread: DJI Forum|Compass info that may interest you We later figured out that it is the VPS causing this and when...