Recent content by woodman12

Thank you. I just wanted to make sure the motors were properly mounted.

I just bought a used P3P and as I cleaned it up and looked it over, I noticed that the motors do not seem to be level. Or at least line up with each other. Are the motors supposed to have a bit of an angle to them? If so, how are they supposed to be? The front ones lean out to the side and...

I am having trouble with saving the settings using assistant 2. how do you do it? I have N3 and connected to Taranis x9d/x8r via sbus. I can sett everything up like I want it to be and then I shut down the software, disconnect to the computer, disconnect the battery, and turn off my Taranis...

did you have any luck getting the N3 and Taranis X9D to work? I have the same setup and problem. I checked out Dennis Baldwin and I only found him working with naza v2. I am just starting my problem solving and hope to find some help here.

I thought I would update my FC40 with an N3. once I started the process of switching over the FC, I noticed the N3 calls for a sbus connection for the rx instead of the two. what are my options? is it possible to use my controller combo?