Recent content by Wendlwacker

I hire out crop dusters for work. They will not spray fields in the wind turbine fields because of turbulence they claim is caused by the blades. Just an FYI

yes I got that far. now I am struggling to get tilt. I have the wire connected to the bottom pin on f2 on naza

Amazon gimbal.... I have another thread called gimbal help..... My frustration has led to creation of threads before taking a breather... Sent from my iPhone using Tapatalk

You are correct according to another helpful member. I am still trying to get my gimbal to respond. No luck yet... I am going to try again tomorrow. Sometimes I just have to step back and let myself take a break because I get a little frustrated. Sent from my iPhone using Tapatalk

Which port in the Naza do you connect the tilt to? The top the bottom or the middle pin? I think that Is where my problem is at now...

now I got that enabled but I still don't have tilt.... on the gimbal

I am trying to enable my X1 channel for gimbal control. I have hooked everything up to the controller but when I move my switch I can feel the pentameter turning but I do not get a response when hooked up to the assistant. Even if I do not have the wire hooked up to the correct pin it should...

Double check your props? Sent from my iPhone using Tapatalk

I did have to go to Amazon. They should be here tomorrow or Wednesday.

You da man!

It was a failure to attach the small pci connector. I had it and then it shifted and I wasn't able to get continuity back. So looks like I am trying to do an antenna mod. Hopefully radio shack or best buy carries the adapters and antennas. I will be after them in the morning. I didn't figure...

Looking for someone that has a stock 5.8 ghz antenna they would get rid of. My wire pulled out and now I'm screwed. This is for the transmitter.

Last night while attempting to access my USB port disaster struck. :evil: The small black antenna wire got pulled out of the fitting on the transmitter.. I removed the silicon around the small coax cable and now have the fitting and the wire. It was not crimped very tight and I think that way...

http://www.amazon.com/gp/product/B00GSIC7AE/ref=oh_details_o00_s00_i00?ie=UTF8&psc=1 I purchased this gimbal as we were discussing in another thread. In typical Chicom fashion the instructions are not correct. The instructions show a different board. The new board is completely different. Can...

I have yet to attach my gimbal by I just positioned it under my phantom and it does appear to clear just fine although the clearance is tight. Does anyone have any tips to doing the firmware? I have so far stared at videos and stuff and have yet to feel comfortable... CAN I USE THE MAC...