Recent content by TacoGrease

  1. T

    Gimbal powering Gopro?

    It should, yes. That said, I wish it didn't - my Zenmuse has now killed TWO GoPro Hero 3 Black's via overheating them... (why 2? Didn't realize it was the Zenmuse doing it until I'd gotten a replacement -_- ) And for anyone wondering, DSLR Pro's customer service continues to be utterly appalling.
  2. T

    Pre Install Micro USB for Zenmuse

    For mine, I used the Aux power cables located inside the Phantom, pulled them through one of the holes in the landing gear (ie what you had to do for the compass cable and H3-2D 8 pin cable), then soldered on a JST male lead to that. From there, my video transmitter - an Immersion RC 600mw...
  3. T

    Real World Zenmuse

    Seems really to be that rear motor that is the issue (which I've heard elsewhere) - gets incredibly hot and smells like something's cooking. Tried connect the GCU to the computer to check/update the firmware, but the computer won't recognize it O.o
  4. T

    Real World Zenmuse

    Annnnd...."Another one bites the dust" Just installed yesterday, after upgrading to the 3.14 firmware (factory firmware for the Zenmuse). Couple of tests, and after 30 or so mins began making that God awful high pitched squeal, before becoming completely unresponsive minutes later. Time for...
  5. T

    One Motor Spinning Sporadicly

    Ah, bummer. I've ordered a new one, hoping to get back in the air soon. Thank you, Audaciter!
  6. T

    One Motor Spinning Sporadicly

    Hi all, Just installed the T-motor AntiGravity motors (MN2214), and, unfortunately, only 3 out of the 4 spool up/idle properly - one of the motors stops and starts, though once I up the throttle this phenomenon stops. During the first test flight after the install, the circuit board for the...
  7. T

    New to the Phantom - Can't Figure This Out

    http://youtu.be/fGZ51lf1_pM Now I am experiencing wobbles similar to this. Multiple theories, no solutions :/ I also downgraded the firmware from 3.12 to 3.0 (could not access 3.10) EDIT: Fixed and flying :D Thanks everyone!
  8. T

    New to the Phantom - Can't Figure This Out

    Recalibrated the Phantom; apparently the red flashes were resultant from an error with the Tx sticks (which I fixed) However, now the Phantom flashes a series of 3 green flashes per cycle, with a gap between cycles. again, I do not know what this means.
  9. T

    New to the Phantom - Can't Figure This Out

    It was flashing 6 times per cycle of light flashes I believe, with a gap between each cycle. Indoors and outdoors :/ Ordinarily I know that the red LED relates to being in GPS mode, but the light flashes continued regardless of mode (GPS/Atti)
  10. T

    New to the Phantom - Can't Figure This Out

    http://youtu.be/Nxp-Aess_uc Not my video, but I'm having the same problem. Unboxed my Phantom and realized it needed a firmware upgrade. So, per the DJI website, I installed the DJI drivers and the Naza-M Assistant Software (v. 2.12). Following this, I upgraded the Phantom to firmware version...