Recent content by Saldivar Engineer

  1. S

    Are compatible the P3S and P3 SE Gyroscope Units?

    Gracias por el dato, podrías compartirme si el cable flex, la plaqueta de la cámara y los motores son compatibles entre ellos también?
  2. S

    Main Board Ribbon Cable Connector

    Trying to revive the LiOn battery I had to unmount the controller and the ribbon cable came out from that FPC connector, now I can't put it all in. Already tried pulling it with tape but nothing. Could someone say if the fix it's to replace the ribbon cable or the connector?
  3. S

    P3 Advanced won't arm, keep beeping and DJI GO won't connect with the aircraft

    I have apparently 2 problems: 1) The drone slightly collided with the wall, replaced the propellers and noticed that it does what video shows ( ⬇) , it keeps making sounds and does not allow arming. 2) On the other hand, the DJI GO doesn't allow me to connect to the aircraft, when I connect...
  4. S

    Are compatible the P3S and P3 SE Gyroscope Units?

    I need to replace the sensor unit which is located at roll motor of a P3S. Can I use one from a P3 Se?
  5. S

    P4P doesn't work well and facing sideward after replacing some components

    I crashed the drone and gimbal got structural damage. So I decided to repair it, however I have come across this problem that I can't solve. :confused: The 1st thing I did was to mount the whole gimbal mechanism from other good P4P (only red part at the image) to quickly discard if there was a...
  6. S

    Need some help: Remote controller signal weak.

    Hi, I decided to replace the whole gimbal in a P3 SE and now I'm facing the same issue. The remote controller keeps beeping. How did you fix it?