Recent content by Rick1008

Yes, and, I think that ribbon is for the new yaw motor I just put in! I had to have messed it up whole installing it! Not sure what did!

Pic of another ribbon wire that got a little damage. Do broke, but not 100% either.

I broke the yaw arm on a hard landing. Replaced the arm, yaw motor and ribbon cable. Put it all back together and the camera is stuck continuously moving up and down. Not stabilizing. Thoughts?

Anyone with knowledge how Intelligent UAS set it up connections for a P4P to use a FLIR Vue Pro, the Futaba R617FS receiver , the FEIYU TECH Mini 2D and the Immersion RC 5.8G. I did not get manuals or anything.

3putts Thanks for your reply. I wish it were that easy. Whomever put this together used a variety of wires between the FLIR Vue Pro, the Futaba R617FS receiver , the FEIYU TECH Mini 2D and the Immersion RC 5.8G. Slowly finding all of the manuals. But, would rather find out how Intelligent...

Help. I picked up a FLIR Vue Pro 336, FEIYU Tech Mini2 gimbal, Black Pearl Monitor and Futaba T7C transmitter and receiver that was set up for Phantom 4 Pro. Did not receive any paper work or set-up instructions. Anyone have experience with this set-up or know what company might have put this...

Thanks for the comments. It's been difficult getting written instructions and manuals. Makes the learning curve steeper, but the challenge has been informative.

I picked up a FLIR Vue Pro 336, FEIYU Tech Mini2 gimbal, Black Pearl Monitor and Futaba T7C transmitter and receiver that was set up for Phantom 4 Pro. Did not receive any paper work or set-up instructions. Anyone have experience with this set-up or know what company might have put this set-up...