Ok, so I got the time today to fly, and managed to test everything again.
I did
- gimball reset (according to DJI procedure)
- reupdated firmware of everything, even though they showed up as updated
- compass calibration before take-off
- advanced calibration (at home)
- mounted...
I opened it up, moved the anti interference board from underneath the battery to the location DJI suggested, on the motherboard. Today's weather didn't allow me to fly, so I will try again tomorrow. Regarding the level of the gimball when off, it is to the left. This is a picture of it off.
Nothing of this sort, the setup is as basic as it comes.
I didn't solder anything, so I should probably check the soldering of what to what ? When off it goes to the left, to the small servo motor on the left of the camera.
I do reissue that this only happens at random times, I resetted the...
Hi guys,
I'm new here !
The plot is as follows, - bought a Phantom 2 w/ Zenmuse H3-3D - had a GoPro Hero 3 White Installed everything as per the instructions, first maiden flight was ok. Now, when I fly, my gimball is going crazy. I take off, fly for a few minutes and then it goes to jello...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.