To me the one on the right looks like it has far more detail. The white lines on the roofs are much more defined than the ones in the left. Plus I like the color better on the right one.
Thanks for sharing!
I flew up the Columbia icefields glacier and then I tried a flight in town and the warden came by and talked to me. I did check the website before I left for jasper and I couldn't find any notice of flying drones (or remote controlled airplanes as he said they were banned). He was nice about...
Thanks
I know the video works as I did 6 flights with it today and it recorded fine. I just flip the hub to vid and it allows me to get video and record it. If I switch the hub to osd I get no video or osd
It is a flysight transmitter with a go pro 3+ ( I tried my gopro 4 as well)
Just doing video only while flying.
I was thinking of changing out the anti interference board but I am not sure if that would make any difference
I just switched my H3-3d Gimbal out for a new one on my Phantom 2 and when I tested it the OSD it seemed fine. I did a flight and it only worked for 15 seconds and then no OSD and then 5 min later no video. I checked all the wiring and finally tried a new hub. The new hub worked again for 15...
I have one of these and it works great for quick switchovers but I find it jams or binds with the bottom of the Gimbal when I try to point the camera straight down. Has anyone else had this problem or am I installing it wrong.
Thanks
Here is an evening flight I did with my drone on a -8C cold night with some light flurries coming down. The University campus where I work is lit up very nice with all the
lights.
http://youtu.be/ikIr_HBxd3E
I am fairly new to drones ( acquired a phantom 2 this summer) but I flew a lot when I had it and made a video that I submitted to a local filmfest. It is all footage from Northwest British Columbia near Terrace, BC.
Northwest Air
http://youtu.be/DB-Kye_DimI
Enjoy
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.