Recent content by JPECORA93

That does make sense. I am wondering about the gain with the 9450 props on. I have read all over that you need to change them because of the bigger props. Thanks for all the help.

I have a 1.1.1 and have a tarot Gimbal on it. I have the 9450 props on it and was wondering if there is anything I can do to stop it from going forward on takeoff because of the gimbal changing the center of gravity? Is there something I should do with the gains? Any help would be appreciated.

Make sure you do jot use the newest driver. I did that and it would install but not initialize. I deleted the driver and installed the older one and it worked great. Good luck!!!

That worked perfectly. It is doing exactly what I want. I only wanted it to face straight forward and straight down and go no further.

I worked with Naza software for hours trying to get to respond in a somewhat normal fashion. Is there something I need to do in the Tarot software?

I have a Tarot 2D gimbal attached to my Phantom 1.1.1. When I use the back lever to adjust the gimbal it is very hard to get it to stop. I have done a calibration on the X1 but it still does it. It is either giving me straight up or straight down. I can get it to stop in the middle but it slowly...

He can probably do anything you want. He really is a great guy. UrAwFuL that is a great skin. Did you have that in mind yourself or did you get the idea somewhere?

I was looking for a skin for my Phantom 1.1.1 and found a ton that all looked the same. I went to RocCityDesign.com and ordered one I liked. The owner Chad emailed me to make sure he had the correct number of the design I picked. I joked and said unless you can do a Chicago Bears one. He...

That is actually exactly what they told me. I emailed with Revolextrix and that is what they told me. Not sure why you think I would come on here and lie to you about what they said. If you read my initial entry I am new to this stuff so no it is not obvious to me. Guess you are not one of the...

CallPro tells me I can build a cable for the XT60. I am just not familiar with the wiring. Thanks for replying to my post. I really appreciate it.

Anyone?????

I have a CellPro 4s charger that has a balance charger cable only on it. I can buy a pigtail from CellPro but I have no clue what I can do to connect it to an XT60 connector. the specs for the pigtail are below. Hope someone can help with this. Pin Color Voltage Node 1 Black 0 Cell 1 Neg- 2...

Thanks everyone for the responses. It really helped.

Thanks. I actually took your advice and got a refurbished Hero 3. only 129$ What would you recommend for gimbals that is plug and play. Not to hand with the flux etc. :D

Thanks. That is what I was afraid of.