Recent content by joe_mamma

The module arrived today, had it replaced in a few minutes and I'm back up and working again. Thanks again Oso

That's a lot of help. I will order that module. thank you

Yah not my best day. ok, do you mean the receiver module? I've tested the cables they are fine

Can someone decipher this log? this unit has a new main board and new camera. I get a no transmission signal error and no video when I start it and can't get it to upgrade. [00014674]========== remo-con disconnect. boot(15) ============ [00014731]Packet [C:\P3X_FW_V01.10.0090.bin] detected...

Just reading through this thread, does anyone have a picture/location of the burnt out transistor on the board?

Thinking I might just scrap this drone out, I can't risk burning another gimbal board. Try and see is not the answer, I was hoping for a more technical response

Does anyone have the pinouts for the pro or the 4k boards?

I put it back on the 4k and there are no lights and no response, it's dead

I'm up to 2 (cheap)new/used ones, I just bought a whole phantom 4k. So if you bolt a Phantom 4k gimbal to your Professional copter it will burn up????

I used the "what if" money I had on the plug in 4k gimbal and it fried....the large cable got hot enough that I moved my finger away. The question is.. is m and spend I'm looking for answers why it fried, if I buy a 4k professional gimbal/cameras and I fries I'm still in the same boat and I'm...

This is exactly what I'm worried about. If I buy another $300 camera/gimbal and it fries the new one, was the 4k comapible with the pro to begin with or am I just setting myself up for another $300 purchase and going to burn up another gimbal?

That would make me feel better about what happened, but as far as I have read it sounds like a firmware problem not a meltdown, what I am worried about is plugging in another camera/gimbal to the pro

Hello, 1st time poster long time stalker. I recently crashed my pro(2' off the ground) that was having some gimbal twitching issues to start with, it separated the ribbon cable, I replaced it with multiple aftermarket then a oem one and it would just go to "gimbal disconnected" on the app and...