8. Are the lights visible for 3 statute miles or more? While recreational flyers do not have a 3 statute mile requirement, Part 107 flyers do. Make sure the manufacturer does say that the light is visible for 3 statute miles or more. If you want to take things one step further, maybe print the...
Can anyone tell me if the blue paste and gray paste used on the phantom 4 pro would need to be replaced/removed before putting new one on if the drone was in the water overnight? Also would that same paste you are talking about above still be good for this one? . Luckily the battery came out...
Now I am flying it today and when started to try to land, it went nuts. It went super fast and had to make sharp turns and kept dropping altitude or wanting to so I was up on the the throttle on the last round, it was coming down so I held the throttle wide open and during most of this last...
Thanks for your response, this is the p4pp so it is the only thing I’ve flown with it. The screen is built in so I can’t use any other device. Glad you didn’t have to kiss him, lol.
I recently had to reset my p4pp quad to factory and now in the go app, my flight time has started over. It kept my skill level 24 but the other stuff is gone. I had over 989,000 feet flown. Any way to retrieve that info
Anyone know the DJI part number for the ribbon cable for p4pp? Or a url to one you’ve purchased non-oem and know it’s good and worked for you ? I’m starting to go thru withdrawals, lol. I have a Mavic Pro to fly but it’s just not the same.
Do you happen to know the DJI part number? I ordered a number 36 overnight but having second thoughts now whether I got the right one. I’d order outside of oem but the last one I got was too short and binds the camera when you look up and when the camera initializes.
I found the ribbon cable was pulled out some from the board where it goes into the board by double connector. Zooming in I could see places where it could have cut or scraped thru the ribbon. Where do you get that cable for 25.00? Is it OEM?
I have the same issue but now after these posts, I don't know whether to replace the camera sensor board or the ribbon cable. Any way to know which one
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.