Recent content by jason197190

OM Gosh, flown only half dozen times but just noticed the foam block today. I see in the "getting ready for takeoff", it clearly shows removing the hard clear plastic gimbal frame, but somehow the foam block escaped me.

Hello Frank, can elaborate on the gimbal calibration? I'm familiar with the compass cal but not the gimbal cal? Is that a feature within the pilot app? Appreciated

Did as you advised. Seems to have taken. Have been getting an intermittent warning regarding "gimbal motor overload" however, believe that is a whole other thread I can chase to figure out from this rev. software. Thx the tip Arizona.

Yes, did the controller as well, same time, same version. Thx for the tip

Thx for the welcome Texas. Yeah seems all okay now, one nagging intermittent message about "gimbal motor overload" but digging thru other threads on that as well.

yep, battery charged, came back with loaded chip and listened pensively for about 20-30 minutes of the louder beep but still heard the undertones of regular software load. A final death bleep then camera jerked back to life, 10 more minutes of regular software load, did an evening flight with...

loaded firmware 1.2.6 today. Got a series of tones after 12-13 minutes so I thought it was complete. I was wrong. .txt message indicated "synchronizing" thus I infer it was not complete. checked a few youtube posts and a few guys warned that you'd get a few more warbles, whistles, bleeps etc. on...

I thought the VPS was only good up to 9'-10'??Swear I read that somewhere in the paperwork?