Recent content by IslandFilms

I realize the problem. I wired all the ESCs identically, whereas I should have them alternating. Thanks for your help, Duke!

Here's a photo of my quad. The directions I described above refer to the bottom-right and bottom-left motors, in regards to unscrewing the blades. Quad by IslandFilms posted Jul 27, 2015 at 7:38 PM

Thanks for your help, Duke. To answer your questions: I bought the ESCs separate from the motors. These are the ESCs I purchased: http://www.amazon.com/gp/product/B00K456LIG?psc=1&redirect=true&ref_=oh_aui_detailpage_o03_s00 And these are the motors...

After a recent crash disabled one of my ESCs and took my P2 out of commission, I just replaced all four ESCs and all four motors (I live in a rusty climate -- it was time for a refurbish). Now, my P2 powers up fine, and all four motors spin fine, but the P2 won't take off -- it's as if it...

Re: Gimbal pitch limited after upgrade ($20 for correct answ Great suggestions! I tried both, however neither worked. Weirdly enough, the solution ended up being software-related. I'd been calibrating my system using the NAZA app for the Mac -- which, as the screenshot above shows, doesn't...

Please read this entire post -- I'm aware this subject has been covered in other threads. I upgraded all the available software for my Phantom 1.1.1, and after doing so the pitch range of my H3-2D gimbal is extremely limited (the lowest I can angle it is currently straight ahead, which still...