Hi Guys,
I was hoping some one could look at the flight logs attached to help identify an issue.
As I was taking off, just as I increased power and the drone was just lifting off, the Go4 app flashed a warning and the rotors stopped dead and the drone dropped to the ground. The warning (I think...
Hi Rod,
I think I need to apologise as I may have incorrectly identified the recording as being the same issue. The recording was taken while the drone was on my desk connected to my laptop to download the DAT files, not being flown. It was taking a long time so I left the room for a while. When...
Thank you sar104 for taking the time to look at these files. It makes me feel better that it appears that basically there was nothing I could have done differently.
One point though, it was not a complete loss of uplink as I could still control the gimbal (i.e. tilt).
ALSO, (something I have not...
That is the same for me, except the drone was only 6meters horizontal and perhaps 8meters directly from me! Drone just went into RTH (I believe due to loss of signal).
Fausto
Hi Bill,
Sorry I was clearly confused when I responded... Thank you for the heads up very much appreciated.
I also understand the frustration you vented in your thread. It seems (with me as with you) that in the post above people just assume human error and that the drones are infallible. I'm...
Hi Rod,
Thanks for the heads up. I have read the entire thread (I think) and it just seems to end without a resolution... Did you ever resolve the issue?
Thanks Fausto
Hi Guys,
While in the process of downloading the DAT files from the drone I had a reoccurrence of the disconnection issue! Please view the attached video and you can clearly see the Aircraft Disconnected warning, yet I had complete control of the gimbal. Exactly as was the case on Monday...
Thanks Rod,
Yes I think my replies were a little hap hazard and that didn't help.
The one thing I would like to stress though, is that it is assumed I initiated a RTH. I did not, until quite a few minutes had passed when I was quite literally trying anything and everything to get control. I...
Thanks for the feedback. I need to stress I did not initiate a RTH. The drone was 5 meters away from me in plain sight, just above a garage I was inspecting. The RTH was initiated some other way, I believe due to a loss of connection with the RC. I didn't mention it in my post, but yes I tried...
Hi Rod,
Thanks,
#1 No
#2 Isn't that the file I already uploaded
#3 What's #4?
Fausto
Hi Again,
It appears I can answer my own question. There are two other files that were created (I assume after my two reboots of Go4). These are attached.
I am so appreciative of your help!
Fausto
Thanks for the explanation. I may be misinterpreting this display, but it appears to end at battery approx. 42%. I was getting critical battery warnings until the drone finally just landed. I assume that was a lot less than 42%?
Fausto
Hi Guys,
Thank you for the replies so far. Answering the question; no obvious damage, just some marks on the blades. I have not restarted the drone as I don't want to loose any data stored locally for DJI to retrieve.
I've looked at the link above to view the log (thanks Rod) and I think I need...
Hi,
Would appreciate some experienced assistance. In the middle of a roof inspection (still photos only) my P4P indicated a compass error (I think) then attempted to land. As it was not safe to do so, the drone just hovered in place. I tried to cancel the landing but the response from the app...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.