Recent content by eweiberg

I had a similar problem with my p4. I would calibrate sticks and it would be fine for a while but problem would come back, and i finally had calibrate every time i would fly and had trouble calibrating the left stick to go 100% to the left point . Ended up replacing left stick control and every...

Thanks for the info. I see a 300A on ebay i think i will buy and change out the left stick.

I will check rubber between shell and controls and check video on utube.

Yes: by sticks i mean the joy sticks. I move both (right and left sticks) several times up,down and around and and get 100% . I get 100% on right stick with no problem, and up and down on left 100% no problem. But have trouble getting left and right movement to go to 100% on left stick. The...

Sticks move freely and are not sticking. I move then up and down and around and when done indication come on i press it.

Drone is two years old. Sticks move freely and are not sticking. I will try a imu calibration and see if that helps.

Yes i calibrate gimble and i get the done indication.

I have been having left stick problems on my P4 standard with the 300c RC. I have been having to calibrate controller just about every time i fly, and have a hard time calibrating left turning. When calibrating everything goes ok until i calibrate the left stick left and right.It took some time...

I have a general question. I have a p4 standard and is the USB cable between the RC and tablet or phone specific to your drone or will any USB cable work? Thanks

Calibrated sticks and gimble today and seems to working fine. Thanks

When calibrating stick will move 15 to 20 % left. Prompt on screen does not say anything about gimbal calibrating it has been working fine.

I have been having to calibrate sticks everytime i fly lately and on the left stick i have trouble calibrating right and left turning. When calibrating left turning on left stick it will not go to 100%. I was able to calibrate sticks today but when flying after about five minutes I could not...

I use one on my p4 standard and works great. Purchased on ebay around two years ago for around 75.00.

Thanks for the reply. I never thought of the controller itself. Over the last two months i did have to calibrate the sticks a couple of times on startup but i got an error message on it. I also had the starting problem twice within the last couple of months but after a couple attempts it started...

I have a p4 standard and when i went to fly the the other day the motors would not start. Everything appeared to be ok with drone and remote as there were no errors on the screen and firmware showed up to date. I am outside of a airport fly zone by about a 1/2 mile, Would this be the cause as i...