Fortunately I have not seen any stress cracks yet. I was wondering if anyone has tried plastaid? I have used it for numerous repairs from hot tubs to toys. It bonds molecularly to the plastic. Here is a link for it on Amazon...
Thank you Slickvolt,, this maybe dumb question but in your opinion is It necessary? I'm really at a loss as to where it goes, I have checked the board over well but no luck. I flew yesterday with success and no issues
No it's not the plug for ac hookup kinda looks locked a mini toothpick with a ring around center an is rubber, about 1/2 inch long. I will post a picture of it in a few
I upgraded my p4p with raptor sr this morning and when I set it down a small rubber (Grey) teet/mount fell out. I have looked everywhere and can't see where it may go. Has anyone seen this or know where it goes on the board? Thanks for any input.
Ya I know, my apologies but I was a tad fed up with terrible support. I first requested refund and that was taking as much time as replacement so I just had them replace. Again sorry for the rant but I sold my K1 so Im frustrated with having to wait so long.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.