Recent content by dennis28

Well I tried the manual re-bind. It worked and I was able to start the motors and all seemed fine. I shut down and after a few minutes I started it up again and it was not connected. I have gone thru the re-bind procedure again several times and they will not connect. I did notice that there is...

I am using a Mac tablet.

With AC and RC on with green lights on both, engines will not start, although I can move the camera. I checked the USB cable earlier and it seems to be fine.

APP = 2.7.2 AC = 1.11.2 RC = 1.9.3

I tried that several times and would not connect. When I first power everything up I have a green light on both the controller and the P3P. When I try to connect the light on the controller stays green until I press the connect button on the drone then both go red and stays that way until I shut...

The light on the controller was red.

Hello, Last time I flew about two weeks ago everything was fine with no problems. When I got ready to fly this morning the DJI app is telling me aircraft is disconnected. I had a green light on the drone next to the connect button. I can also move the camera from the remote. I tried to connect...

Thanks, I will order these today. My first thought was to take it apart and renforce with fiberglass. The solution you suggest will be a lot easier. Dennis

Hello, I just finished a flight and was examing the drone and noticed cracks in the lower shell under the forward port motor. I didn't inspect before I flew, if I did I would not have taken it up. My question is if there is an effective way to repair this myself. This drone has never crashed or...

I watched the video and followed the instructions. The LED blinked only for a few moments then went solid green. I am still getting the same message. I have attached the Result file. Is it possible to go back to a previous version of software that would not have any of the restrictions and is...

I was not able to fly until I upgraded the software from v1.10.9 to v1.11.2 I uploaded the new version but was unable to get a success message. So I started over by reformatting the card and I get the report that says could not replace the bin file as it is already in there. I am reluctant to...