Recent content by David Cohran

I too crashed mine back in January. I broke the Gimbal arm and ribbon. I replace both but used an aftermarket ribbon. The gimbal did nothing. I purchased a ribbon from DJI and replaced again. Now the gimbal moves but bounces back and forth, not its normal calibration. It has been sitting in the...

Finally, removed the aftermarket ribbon and installed a ribbon from DJI. I am now getting movement when I power it up but it is just aggressively bouncing all over the place.

Hunch , I did something similar to this guy and replaced the ribbon and yaw arm. Everything appears to be good until I power it up and the gimble does nothing. Does not move at all. I posted a video on Facebook and someone posted immediately a broke motor. I would like to send you video to you...

I did find that I installed the camera backwards. I removed it and turned the shaft to where the half moon was facing to the rear. powered it up and found that still noting is happening except a little vibration and there intermitting beeping/grinding sounds. This is a photo of what's showing on...

I power the unit on and it does not move at all. I hear the gimbal making a scratching noise like the brain is wanting it to do something but no response. I crashed it and broke the yaw arm and ribbon. I replaced the ribbon and yaw arm. Now nothing. I was just watching a video and now thinking...

How do you do a IMU calibration?

I power up the machine and where the camera use to move in different directions, it does nothing. I hear it making a noise but nothing is happening. I see the green light on the front on like its trying to read something. Any Idea?

Can someone please tell me how to start a new question on this site?

I feel you are correct. I assume something like this is not covered under the warrantee?

Thanks for you help. It was not under the trees, out in the open. The whole flight from exiting my truck to end was strange and abnormal. to start I turned the bird and controls on and it was difficult to get calibrated. The controller kept saying something I couldn't understand. After 3...

Therealnick, I looked at my track and right before it struck the tree the mode went to Opti then atti. My controls were neutral. It drifted into the tree. I'm not sure what you mean by .dat or how to load any data on here.

I would be don't know how to do that. I haven't even figured how to look at videos I've taken. Just have been learning how to fly it.

I spoke to a DJI rep today and in my case, he was quick to say pilot error (as expected). I don't want to send it in and it cost to repair half of what I paid for the device. I asked what about it being a malfunction of the craft and he said the can tell what happened with the use of some...

I had the same thing happen, meaning crash. Except I don't know if I flew it into, the wind took it, or it malfunctioned but it hit the tree 20' up. My heart sunk being it was only my third flight. I walked up to it and the camera was laying separate from the craft. I though immediately there...

So we are suppose to discharge our batteries? How about the RC?