Hi, unfortunately no. I tried swapping the knock off ribbon with a genuine cable (as far as I could tell it was genuine anyway) it was from amazon for $80 but it didn't fix the issue. The solution would have been to buy a new camera because the gyro chip is in there. The cost was too high and...
Ok I will read about the different parts as I'm a bit lost. I'll get back to you shortly.
I found a thread describing the same issue here Phantom 3 limp gimbal and gyroscope error
I see you were active in there, do you know if the issue got resolved?
Thanks for your reply.
Yes it is completely limp, There is no resistance from the motors when powered on. Only a slight noise that gets louder when they are shifted.
Is there a relatively simple fix for the main controller without replacing it? Or might the issue come from the sensor board...
I crashed my phantom 3 standard and had to replace the yaw arm and roll motor.
I also replaced the ribbon cable with a genuine DJI part, now on startup the gimbal doesn't move at all and I can't move it with the controller.
The main board LED is solid green.
Anyone have any suggestions?
I crashed my Phantom 3 Standard and had to replace a damaged yaw arm and the ribbon cable.
Now when I power on the drone the gimbal doesn't move at all, I can't control it with the controller.
I repaired the yaw arm and replaced the ribbon cable with a knock off ribbon at first and had this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.