Recent content by agestam

Thanks! I figured the easiest fix was to get a new dji 2.4Ghz system and just switch. It was in my price range too.

Thanks! I'll check it out! Otherwise I'll just switch the receiver and buy another 2.4Ghz controller.

Is that really possible? Have never heard anyone being able to use the GoPro and H3-3D with a tablet... That would be cool, cause I already have the wifi stuff! I saw that I probably can buy the spare parts for a 2.4Ghz receiver and switch system inside the phantom, and buy a new 2.4Ghz RC...

Hi, just realized that my RC is not a 2.4Ghz system but the 5.8Ghz Phantom Vision version. Now I already invested in H3-3D, GoPro and FPV 5.8Ghz. Wondered why my range was so short! :p What do you recommend investing in? Another Phantom 2 basic to put all my equipment on or buying a new Futaba...

I now checked the video signal right before the TX and the only possibility I know now is that the TX is burned. But I also wait for support from the reseller!

Could the gopro cable connecting it to the gimbal be broken even if it is charging the gopro? Is it common?

This is the hub. I have tried all channels and I see a flickering when switching channels on my RX so I assume that is working. And both gopro and monitor is on PAL. Also tried to switch the hub from OSD to Vid but with no luck. According to the AVL58 manual troubleshooting there should be...

Thank you for your answer! I will try all this tomorrow and see if it works, I found a potential fault in an exposed cable..

I mounted a H3-3D with gopro, iOSD Mini, AVL58, everything was working fine! I got good picture quality with OSD on my monitor. Then suddenly the there was no longer a video feed when I tried filming. The GoPro is still shooting but I cannot get FPV. I have not been rewiring anything, and both...