Thanks for that tidbit!
for some reason I thought that I read a long time ago that if you pressed c1 and c2 simultaneously it toned down the collision sensors.
I have searched all over and I cannot find an answer to this. A little help is requested.
when flying a P4P into close proximity to objects, isn’t there a sequence on the controller buttons that you can tap or hold down that will allow you to fly into tighter areas?
thanks. In advance for...
Thanks for your input!
See attached image from my iPad. Pay attention to the sides of the football field. I flew directly down the sideline but from here you can see that it is off.
flying a P4P on an iOS system, latest firmware and Go4 app.
I’ve set the battery warning and critical warning alarms respectively in the Go4 app. However I get the first warning at 30% which I don’t have it set for. I’ve verified the percentages and they are set to the values I’ve set them to...
flying a Phantom 4 pro and 4 advanced on an iOS system, same results with both ships.
I’ve created some missions by flying a route and creating waypoints as I go for later use. When pulling the mission into Litch mission hub or into the app, I’ve noticed the map is offset by amount 3 meters...
I placed my order through DJI right around Christmas time when this thread started and never heard a peep. Last week I fired off a nasty gram asking where the hell were they and suddenly my order arrived 3 days later expedited. Just saying.
Welcome to SA! I've never ran into problems downtown but don't get close to the crowds and especially the Alamo since it is a bit sacred. The majority of the Riverwalk is covered in trees so it may be tricky. I've flown high to get the buildings and such.
There are some apps out there written by individuals that will allow you to flash the unit and install an older firmware if you have a copy. That too can be downloaded if you know where to look. It's not that hard to find. I'll refrain from giving any details out of the backlash that I may...
I too was having weak signals and very poor connectivity with Litchi and Autopilot. Reverted back to an alder firmware and full functionality and stronger signals came back,
Yes well aware of that. I just noticed that it keeps alarming me at 20% and initiates a landing, even when the settings are set to 16% and 10% and i am flying withing 200 feet of my takeoff spot. Weird. I was curious if others had experienced the same thing.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.