Hi, I have a phantom 3 standard with the GPS connector ripped off the board. 4 of the 5 pads were intact and thanks to the part number from Oso, I got a new connector and soldered it on.
Problem is, the pad for pin 1 ( white silk screen dot) is gone and I can't follow the trace to add a wire.
Anybody got a schematic, or have the lid off and a multimeter handy?
Thanks
Sorry if this is a repeat, but tried searching; "schematics", "pinout" etc and couldn't find an answer.
Problem is, the pad for pin 1 ( white silk screen dot) is gone and I can't follow the trace to add a wire.
Anybody got a schematic, or have the lid off and a multimeter handy?
Thanks
Sorry if this is a repeat, but tried searching; "schematics", "pinout" etc and couldn't find an answer.