Recent content by xmozzodrone

In fact, I noticed that with the USB connector attached the mobile phone or the tablet is recharged

Hi, thank's for your contribution. I tried to unistalling and reinstalling the DJI GO APP for product before P4 (VER.3.1.43) both in the tablet NEXUS and on smartphone SAMSUNG. Next the installation, i reboot and connect RC to device and the app doesn't start automatically. Both in the tablet...

Excuse me I was wrong to answer you. When I connect RC to the computer I use a microUSB and fullUSB cable, while to connect RC to the tablet I use the same cable but turned, fullUSB on the RC side and microUSB on the side of the tableto or smartphone. I use the same cable but on 2 different...

GL300a contains DaVinci media processor on the Interface Board. Firmware of this chip often gets de-programmed over time. This is likely the issue. wiki on GL300 Interface board do you think I need to do the firmware dowgrade? I tried to update this firmware "P3S_FW_V01.11.0020". I also...

Did you used the same USB port on the RC to connect it to PC, as you used to connect mobile device? (I'm not saying you should, just pointing that out) yes

Is the mobile device charging? Are you able to read kernel logs on the mobile device to make sure no hardware is detected by the kernel? Also tried an iPhone device but it does the same thing. Nono are able to read the kernel logs, I do not know how to do it

See the image attached

Hello, thanks in the meantime for your answer. The main problem is that RC does not communicate with the tablet or smartphone. When I connect the USB cable between RC and TABLET and open the DJI GO application it does not allow me to enter and it gives me the writing "HOW TO CONNECT" instead of...

Hi, i have a problem with my phantom 3 advanced. I can not connect my mobile phone to the DJI GO app. I tried to change usb cable, to update the firmware (last available). Anything. Can someone help me?