Recent content by Wheel69

Thank you for your help. Happy droning!

Thanks..I prematurely posted.. I searched the forums and found a similar question. Then I risked my craft and flew it about 15 feet off the ground, and performed left control motions. All was good. I behaves better than before. Perhaps the firmware updates where of help. Thanks for you support.

Hi, I have a P2 that I have recently had to some moderate repairs (replace main circuit board). After lots of trial and error I have manage to iron out several little kinks (reverse stick, gimbal H3-3D bricked). I bench tested the P2 and I was concerned about the left stick. If I place the...

I was able to partially solve my reversed stick. I was using a MAC and the assistant was not showing my option to switch the controller. So I used my OLD pc, downloaded the RC program and was able to select the proper MODE 2. I say partial because the sticks are back to original behaviour...

Hi, I am not sure if I can help you. I also have a P2 with H4-3D. for about 2 years now. I was never happy with the low quality video transmitter, so I recently purchase a 200mW immersion vid transmitter. The plugs on my drone happen to be the same. So i plug them in...oops, mistake. the...

Sticks switch sides...up and down are on the right and fore and aft on left. Also if I hold down the right stick it shuts off. Not what I would like with defending (like a rock). I have tried Rc and Assistant apps, but not able to switch the sticks. I am worried I accidentally plug a wire is...

I was able to update the circuit board and fix my video link, with an immersion 200mW transmitter. However still not flying as the controller sticks are reversed. Tried software changes with not success. Suspect a plug inside is misalign or plugged into the wrong port. not sure.. took of...

I am hoping I know my answer. I will replace the central circuit board.

I bought my P2 over in 2014. I have always had video transmission problems, poor quality more that 750 feet. I want to try another transmitter and purchased a immersion 5.8GHz 200mW. I think I may have accidentally connected to he power in reverse polarity. The immersion power wire is switch...