Recent content by Valhalla_Bound

I am almost finished rebuilding my p3 standard but I ran into a problem. I went to connect the grey and black antenna wires to the gymbal and I noticed the black wire connects to the left of the gps plug. well it seems i connected the other end of the black antenna to the opposite side of the...

Thanks a bunch, found it on ebay but was coming from China, found the same set for about five bucks more shipping out of PA and I live in Connecticut so it should be here within a week. thanks a bunch!

What is this set called? I wanna buy it

Hey guys I'm getting ready to replace the shell on my dji phantom 3 standard I was under the impression all i needed were a T6 and T8 but while trying to remove the camera I noticed the screws holding the covers for the antenna's was smaller then my smallest Torque which is a T5 can someone...

I heard that some higher end Micro SD cards need a special reader is this the case with any of these?

Sweet, thank you!

Hey guys, I was wondering if anyone can point me in the right direction for a good SD card for my P3S Something that won't break the bank but still do a good job. I am looking for a 64gb

Has he ever tried working with owl feathers???? lol

Here is a link to a video I made of the issues i'm having. In this video you will see four anomalies as they happen.you will notice I'm not hot dogging it so i'm not sure whats up. let me know what you think either reply here or comment on the video. Thanks!

It seems to be but I will check to see if a grub screw is loose.

Let me see if u can answer all these questions. Yes I use DJI go, on my 2nd flight I did in fact flip it over but only a foot off the ground and it worked fine after this. Yes I secure the gimbal during transport. Yes it does its herky jerkey during its start up cycle. And no I don't calibrate...

Hey people. I've been taking note of an anomaly that happens periodically. When reviewing my footage I've noticed the gimbal will suddenly and wildly swing to the left to the point that you see the landing strut then corrects itself. this will only happen a couple of times during flight and...

Thanks a bunch this was helpful I made a mistake myself calling myself Valhalla bound but I added an H to the bound LOL

I'm not sure if this is the same issue as yours but the problem I've been getting is the gimbal periodically will wiggle to the left every so often and all I see is the landing strut. It happens at least one or two times during my flight. I have a phantom 3 standard