I got one of these, it is ok but stops recording if you get a break in the feed back, say you go behind a tree and the signal breaks up a bit. You need to remember to start recording again. I eventually got the Fatsharks with built in DVR and they record all of the time...
Re: My new Lake District video captured with the Phantom 2 &
Great video, Borrowdale is my favourite part of the world and I spend a lot of time there. Enjoyed it immensely.
I have the Spironet ImmersionRC 5.8GHz Antenna Set which are very good but have now moved onto the IBCrazy 5.8Ghz BluBeam Ultra Antenna Set and I think they are fantastic.
Are these actually on sale anywhere?
I have seen a lot of hype about them but cannot find them in stock anywhere. Does anyone have any idea if or when they will be readily available.
I am beginning to think there is some sort of production problem with them.
Any replies greatly appreciated.
Bob
I strengthened mine with thin strips of gaffer tape and it seems to work. Prior to that I busted mine after just two outings but since adding the tape it has been OK. I ordered seven spare ribbon cables, thinking I would need all of them but have actually not needed any. I should add that I now...
Try Fast Lads or First Person View, both U.K. and both give great service. Just make sure you order the correct type as there are SMA or RP-SMA. Either of the above will advise you if you give them a call.
Bob
Hi Harry,
I put a 90 degree adapter on mine so the antenna points straight down and it also protrudes below the skids so I never get break up of the signal caused by it's orientation in relation to the gimbal. I use two blocks of wood to take off from, (this keeps the antenna off the ground) and...
Hi Harry,
Thanks for that advice but both myself and Heliguy were at a loss as to the reason the update made the gimbal operate this way so I therefore thought it wise to go back to 3.04 ( never had a problem with that version except Gopro not quite level). It made me think that maybe there were...
Mine did exactly the same thing. I even recorded video of the fault and sent it to to my DJI dealer.
The only solution that worked for me was to revert back to 3.04
If you are in Europe this place got stock yesterday, I ordered 4.
http://www.globe-flight.de/DJI-Zenmuse- ... ble-PART56
A bit fiddly to change but then again I have hands like shovels!
We'll I got lucky. My U.K. supplier, Heliguy, is sending me a replacement cable out in today's post. They did offer to fit it for me but I chose to do this myself to save posting it to them.
Going to strengthen this one with duct tape at the point where it broke which is the join with the mini USB.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.