Recent content by steve1two

I'm not sure if a solution to this has been found yet but I want to add a few things because I only have this new controller after it replaced a unit that I had problems with. This is a problem that is only with the new controller that ends in "B". I had both an A and a B side by side for a...

The beeping just happens to be what the controller does when you leave it on and don't use it. I noticed it a couple times in unrelated circumstances and I'm assuming it is just a "hey, turn me off" thing. I also spoke with support and they told me the same thing. Also said it would say in...

Well, here's the good news. I just unboxed the one that I am sending back and plugged the controller in to the gimbal. Does the same thing on my first unit (camera goes down and beeps) when the controller is plugged into it. So as far as that instance, that was just my ignorance to how it...

Well that sucks. Now I'm worried again. Yes that does sound like what mind did - facing downward, just mine had a beeping along with it. Yes, I did update to 1.2.6. I am relatively new to this and it never crossed my mind that a firmware update could possibly cause problems. But I'm not new to...

What do you mean by go limp? On my first start my camera pointed down and kept beeping. Then I tried updating controller firmware by hooking it to gimbal, camera pointed down and kept beeping. However whenever I have it link to the controller everything seems fine. I did update firmware -...

I did find that this update does not have one for the controller, but there are still two problems in my mind - What version are they shipping with at the moment (a really old one that still needs some update?) If I try to run the 1.2.8 update on my other remote control it still writes in the...

So very first time I started my P3 up it had both IMU error (please calibrate) and gimbal cannot receive MC data. I did an IMU calibration and both errors went away. Now just about every other time that I start it it will show both errors briefly and then they will disappear after a minute. I...

I just had to get a new P3 - I had some problems with the first that I received and the company sent me a replacement with a return label to send the other back. I'm currently sitting here with both. I tried updating the controller (would it have shipped with the most recent?) - no matter what...