after a few flights, the camera was again a bit out of centre. Better than before but still a bit to the side. I pushed the camera to the other side to recentre it again, this works. But this i have to do every time now i think
edit: ahh i see, maybe i have to do all the calibration things...
i also have one more question. I was so stupid to interchange two propellor motors on the drone. I fixed this by changing the white caps on the motors, otherwise the propellors won't fit. The drone is flying normally but i don't know if this can give any problems?
wow thanks Tony! I was a bit sceptical about this solution but i tried and it works:). The camera is exact in the middle now:)
it is strange you can't calibrate the motor softwarematically but maybe they do this on purpose to avoid people are going to fix there own drone
so if i understand it right, i have to buy a new yaw motor and replace with the old housing. But i have already placed a new yaw motor as said in the beginning. if i replace it with the old housing will it be oke?
Hi all,
I had a crash with my p4p. The yaw arm broke incl the flex cable and the flex cable of the yaw motor.
I replaced them all. But when I start the drone now it is facing to the left. When i push it to the right it takes a while to go back to the left position instead of going immediately...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.