Recent content by Scalpel78

  1. S

    Unable to charge battery in DJI charger?

    Thanks, I did the tests, and the voltages seemed reasonable. When I then plugged it into the charger it suddenly worked. Not sure why, cause it doesn't seem like there are any loose wires, and I connected and disconnected it several times last time I tried, but this time it behaves like it...
  2. S

    Unable to charge battery in DJI charger?

    Hi, for my FPV setup I've bought this battery that I use to power the monitor and the RX. http://www.ebay.co.uk/itm/Turnigy-Nano-Tech-1300mAh-3S-11-1V-25-50C-Lipo-Battery-Pack-RC-Plane-Heli-Car-/230957381350? I assumed that I could charge this battery using the DJI balanced charger, but...
  3. S

    Senrigan GP-35 gimbal?

    Flew with the Senrigan GP-35 gimbal today, and seems to work like a charm :)
  4. S

    Tri blade propellers

    I just bought these from ebay: They should fit, right?
  5. S

    Tri blade propellers

    Where did you get the tri blades for the Phantom?
  6. S

    Senrigan GP-35 gimbal?

    I've recieved my Alware Senrigan GP-35 gimbal, and have it mounted to the Phantom. I haven't flown it yet, but tests here on the ground look promising. I just had to assemble all the parts, and power it up, and it works as it should. I also got the tilt working with the 7th channel on the stock...
  7. S

    First flyaway

    Were you low on battery? Sounds like it went into failsafe mode (because of low battery), rose to 60 feet and headed for the Home-coordinates, but didn't have enough juice to make it there. It is unfortunate that whenever someone looses control of their Phantom it is referred to as a Flyaway...
  8. S

    Erratic turning of motors

    Hi guys, I replaced the screws, but the motors are still not turning properly. I guess they got damaged then :( One of the props spins almost normally, and the ESC LED lights up. The other three motors just rattle about, and the LEDs do not light up. Raptor, how can I be sure the ESCs are not...
  9. S

    Erratic turning of motors

    Thanks guys! Excellent answers :) Hopefully they aren't damaged :/
  10. S

    Erratic turning of motors

    I was also assemblying my Senrigan GP-35 gimbal next to the Phantom at the time, and noticed that my screwdriver became pretty magnetized at the time. Could exposure to magnetism cause this?
  11. S

    Erratic turning of motors

    Hi, my Phantom has been working fine for weeks, but I got a weird issue with the motors now. Today I changed the legs to the SimonSays foldable legs, and also removed the propeller guards. I haven't opened the body. When I tried to start it all four motors were moving in a very slow and choppy...
  12. S

    Senrigan GP-35 gimbal?

    Hi, has anyone tried the Senrigan GP-35 gimbal? (http://www.flying-hobby.com/senrigan-gp ... 12140.html) I've ordered mine, and waiting for it to arrive... Just wanted to see if anyone had any experience with it?
  13. S

    How to power the DJI 5.8GHz Video Downlink?

    Hi, I've bought the DJI 5.8GHz Video Downlink (http://www.flying-hobby.com/dji-58ghz-v ... 10854.html), and now I'm trying to figure out what the best way to power the TX is. The cable attached to the TX has a Dean-connector. I've bought a Dean-to-XT60 poweradapter, but I'm contemplating just...
  14. S

    Right drift

    Hi, have you tried hooking it up to a computer and do an Advanced Calibration?
  15. S

    Name of powerplugs?

    Hi, does anyone know the name of the plugs in the center backside of the Foxtech M500 display? The two + and - holes in the middle of the back, not the power in the lower left corner (or perhaps it doesn't matter which ones I use?) I'm trying to google for a cable I can put between a battery...