I bought a backpack for my Vision 2. Its a generic one I got on ebay. Everything seems to fit pretty well but the camera seems to dislodge even with the plastic stabilization support piece clip thing. Any advice on what I may be doing wrong? Could the pack be wrong sized?
So tried doing an advanced calibration....got a warning it was too hot. Took it out anyway and flew - seemed ok. Not quite sure because there was drift and it was windy.
This morning tried advanced calibration again - too hot - tried it 3 different times and finally just let it go it seemed to...
Got new motors and bit the bullet and did the install myself. Started the drone late last night and it started fine no issues motors sounded really nice. Is there anything else I need to do? Update the apps or...IDK. Trying to figure if I bring it to Iceland next week but not sure yet. I only...
Thanks - I saw a video where to put in new motors he just spliced the wires and then soldered the connection and wrapped there. May go that route. But thanks for the info about the high tin.
I have been flying a 3s robotics solo for a while and went back to phantom. Got it out of the pack started it up...motors don't spin but shake. Look up issue on my phone and it's because I didn't install the prop guards and screws killed the motors. F ing bad design.
Oh well...it's done...
I ran my own company for years and if I would have given up after a few hundred fliers...
Anyway I know it seems like you did a lot of work but you might want to think in terms of doing that level of marketing at a minimum every day. AND follow up with a phone call because you quickly learn...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.