Bought the P3A used
Bought the gimbal top board off banggood, updated aircraft firmware but it appears didn’t finish updating camera firmware. When I disconnect gimbal it tells me the aircraft firmware but not while it’s connected
Bought used, gimbal turned on moved around and pointed straight like normal but no image transmission gimbal disconnected Would not recognize sd card etc
Bought new top board and installed. Still no image/gimbal disconnected but gimbal would center etc. downloaded latest firmware...
Did you get an answer? Same issue, just bought a top gimbal board from banggood and hopefully thats the answer. I just dont think its the camera module board because it doesnt read the sd. If this is not the issue then i will order that next.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.