Recent content by rpm3

Ok, I turned off VPS, and tested it on the same Litchi mission....no problems. I’ll watch it for awhile, and continue to review the airdata info....

I need to verify, but I haven’t noticed the behavior in a non-Litchi flight

Thanks Mr Dawg..... I fly manual, as well as Litchi, yet this only seems to manifest itself with Litchi...but I absolutely do NOT think its a Litchi issue.... I probably just don't notice it in manual... ...as a side note....if I were to replace the "board"....where does the DJI drone ID...

Thanks fellows....I will test it this weekend if the weather cooperates....it is very strange...if turning off the VPS corrects it...I guess I'll have to be satisfied with that...but I have a feeling it is a symptom that could be related to other issues.... This is the SAME drone I posted on...

Thanks in advance for your thoughts Phantom 3 Pro Ipad Litchi (newest firmware) Clear day-flying LOS IMU was updated prior to flight (in anticipation of possibly correcting the issue) Waypoints are all set to an identical altitude 127' This "bouncing" does NOT happen at a waypoint... Issue...

hmmmmm........thanks Dawg, great information.....just not sure where to go from here....I suppose I can open it up and take a look....see if anything is physically, and obviously wrong, but my expertise is limited on the inside of this drone.....early on in my drone days, I modified, and added...

So yes...there can be 2 different mission ending events, one involving the controller, going into ATTI mode, and no lost satellites, and another involving the drone, with a GPS antenna issue....at ALL times the controller shows 100% signal. The antenna I installed many missions ago... ITELITE -...

Thanks, I noticed that too Flydawg….in the mission showing no dropped satellites, what I was thinking is that it lost all satellites long enough to lose connection, but not long enough to record the event.....but maybe it doesn't work like that.... I gotta believe that the mission ending, and...

OK then, how would you go about troubleshooting this? Thanks sar104 for the confirmation.... So, I've flown probably this mission 20 times....some before AND after these 2 GPS failures, and not had this issue. It happened so abruptly, it seems to be a hardware issue, not software....it also...

Thanks Fly Dawg... there are the DAT files, right off of the Phantom..., as well as CSV files from Airdata https://www.dropbox.com/sh/kqecg018ifgbunz/AAAQKNcw5vky69sXt-UfHSAqa?dl=0

Pardon me if I’ve missed some posting protocols….kindly point me in the right direction if so! OK...(long post), but I'm looking for some confidence building feedback!!! It was recommended to me to ask for the analysis of @sar104 and/or @Meta4. Phantom 3 Pro, Litchi App Ver 2.6.2 Mission...

I'm looking so that I don't have to "tear" apart the gimbal assembly every time I want to fly without my GoPro and gimbal... The cable mounting to the gimbal is so badly placed, it must have been on purpose?!?.... If I ever find one I'll let you know...if you could do the same that'd be great...

FDNY..hey there...did you ever find the source for the 8 pin cable extension for the Zenmuse gimbal? thanks Ralph Matile