Recent content by robport

I had the exact same problem with a Yuneec Typhoon H, but I had physically damaged the board while trying to replace the lens.

I'm afraid it was the beginning of something, but was hoping it was a known failure mode, if it was. It was about 180 good pictures, 54 bad ones, then another 20 good ones that day. I went out and did a full apartment complex today and didn't see it. I haven't been able to reproduce it.

This is on the raw and jpegs and all three exposures. The red appears to be fine in the oranges. I use ACDSee to view/adjust and Aurora HDR to process the brackets. I also looked at them in Luminar AI. I can make it look halfway decent by dropping that particular color, but the whites...

I'm normally set to take multiple exposures and RAW/JPEG, so I don't have to go back. This is actually a composite of 3 exposures, but the color is there on the Raw and each image.

Last week, I had a job and in approximately 1/3 of the pictures, cyan replaced white. This could not be corrected by changing the white balance or in post. Anyone seen this before and if so, come up with a fix for it?

It may be a pain, but it's a totally different type of issue. RID will not keep you from getting a job done. DJI "Fly-Safe" does. By the way, I emailed DJI and explained the problem. After telling me I should send them all the information well in advance for them to unlock a...

I'm risk adverse. In case something goes wrong, I don't want to have to say I modified the software with something the manufacturer didn't approve. Been trying to unlock it for another place to fly tomorrow for two hours now. No luck. I must have gotten on one of their lists or something...

I stopped using Airmap because some of the zones in my area are inaccurate...totally missing one of the major class E2 areas around here (also shown on the FAA facilities map). I sent them an email, but never heard back from them. I've been trying to get an unlock from DJI's fly safe site...

New problem now. Been trying to get an unlock for 6 hours now. Supposed to fly tomorrow and the next day. Guess I won't be using the Phantom again It doesn't send me a verification number and when I repeat it, it tells me my phone number is wrong.

Is there anyone to talk to about the DJI "Fly-safe" system? Twice in a row now, I will be unable to fly my Phantom, first time (last Thursday) in class G airspace with a rarely used airstrip about 4 miles away and this time, in Class D airspace with Military tower and the FAA's permission, but...

I flew it, but I still don't understand the rules. I had both areas unlocked and uploaded to the UAV, but according to their documentation, only one could be active at a time. I took off with the class C one activated. At about 25 feet, I got a no-fly zone warning and the app said...

Tomorrow, I have to fly at the intersection of two blue airport zones on the Fly-safe web sight, one Class C and one Class D. I have the FAA Authorization and technically, the Class C airport makes the decisions. Am I going to have trouble with the Phantom recognizing the other airport and...

You can submit a request for 300' in a 100' location through LAANC (I was told by the FAA that they don't want you to use Drone Zone if it is a LAANC covered area. They complained about it when I did it). I have to do it a lot (you have to give them 48 hours for special review, but you still...

I should have been more specific. I was looking for opinions about using a 107.29 waiver to fly over an airport as a stunt. It could have been a private airport and he had them turn the lights on, but he should have said something about that so he didn't encourage his followers to do dumb...