Recent content by robin.symonds

I did get it working. I found if I deleted the Driver installation software and the RC Assistant software then re-installed them I got connected again. Then just recalibrating. Thanks for your advice and comments.

I did get it working. I found if I deleted the Driver installation software and the RC Assistant software then re-installed them I got connected again. Then just recalibrating. Thanks for your advice and comments.

Hi Luv2cmwork I'm running windows 10. I checked in device manager whether anything happened to Ports when I plugged in the RC. It did. So I uninstalled the DJI driver and the RC assistant software then reinstalled them with the RC plugged in and powered up. S1 and SW2 both in Mid position...

I seem to have bricked my RC by uploading some bad firmware. No lights on the controller... no connection lights on the software...nothing Can I flash the RC by some other method straight through? Thanks for any help Robin

Everything was going fine until I was in RC assistant. I updated firmware to what I think was suggested in the Info section and Blam!! Not even the power light comes on. There is no connection to RC assistant so I cannot go back. Any help much appreciated.