Recent content by RcVision

I try to upgrade from V1.08 to the new one - V2.0, but get this message on the bottom side of Assistant 2.0 - "you must update main controller firmware". When I`m go to the "Upgrade" in Assistant2 I got that there is no firmware updates - I have also try to uninstall V1.08 and after install...

Taco-rc support is very slow, I got my responses after 1 day's wait. So, during the whole week I received just a few troubleshooting suggestions, but they were pretty useless because I had already tried out these operations myself. This is the 6th day since I haven't received a reply from...

Yes, I make these all inspections before....everything is correct.....I don`t know what else... I`m waiting response from taco-rc...

Re: 3DPower gimbal tilt/pitch issue I try it with free space under the camera - no reactions. Also try without filter kit. Gimbal is balanced with weights at the camera backside and stay in the horizontal position very stable when it is switched off. As I say before there is no reaction on the...

3DPower gimbal tilt/pitch issue Just installed 3D Power gimbal on firmware V1.08 and App V1.0.38 Tilt function didn`t work from DJI Application. When I change Pitch values in the Assistant gimbal didn`t move. I try all firmware versions and all versions of App, but have the same problem. I...

Problem resolved. Cahnaging Z and Y axit to - Z -Y

Yes, I try put back V3.04, but it also shake. Is it possible to make some gimbal corrections in "SimpleBGC_GUI_2_2b2" ??

It is 3D Power gimbal. I installed it and everything woks fine. Also balanced it for lens kit. After that I downgrade firmware from 3.04 to 1.08 to get activate X1 tilt function. It didn`t work (tilt f), after that I get this shaking. It is problem in the Gimbal?

Sorry, not P2, but P2Vision with gimbal. Cant find any thread with similar problem. After downgrade from 3.04 to 1.08 get this gimbal shaking - https://www.dropbox.com/s/ecg9ehv1m5h6s ... 103805.3gp Where is a problem???

Installed 1.08. Calibrating is working, but when I reboot all - X1 isn`t work Also loose tilt control from App. :?

Can you please tell me where can I download these old firmware versions? :roll:

I have Phantom 2 Vision :P When I open Assitant V3.0 and it was not possible to find X1 calibration. Then I downloaded Assistant V2.0 , but it always shown this message - "update main controller firmware to new version", although the newest version is already installed. I find in this thread...

****, I hate this day when I decide to buy P2Vision !!! 3 times get defective camera and today - flyaway with crash in FULL speed! This is a long story about lot of defective cameras. In one word I can say, that this is a full DJI negligence!!! About flyaway. Today I get third camera...

Phantom Vision Only few times flown. 1) Defective camera (mist in the right side of photo/video) 2) One of the motors is "growl" (only few times flown) 3) Range extender defect (didn`t conect with new camera(replacement)) tommorrow I will ship second time back my aircraft! Very...