Recent content by Randyfthompson

Make sure your Home switch on your controller is not turned on. Being too close and having the Home switch "on" May cause it to flip.

That happened to me because somehow I had changed the mode of the transmitter took transmitter apart and plugged into the mini us band switched it back. Had to download software to do this from DJI site. That fixed it.

Recently had a bad crash when one of the engines failed on my Phantom Vision. Hit pavement hard enough to dislodge camera and it is no longer working. I can shell out $499 for a replacement, or sink the money into a H3-2D Gimbal and mount one of my GoPros, I just won't have FPV. I keep going...

Had a nasty crash where one of the motors or the ESC failed. Tumbled about 40 feet onto a parking lot. Banged up but no too bad. Got a new ESC ordered and will see if that fixes it. But suddenly my camera quit working. I checked it out right after the crash, because the mount for it ripped, but...

If you just keep us posted on your progress and some weekly tracking numbers, that's about all I need.

Tried that already. Phantom little red light goes off so the TX is connected. But I have a persistent yellow light on the Transmitter. When I first power it up, it goes green...give me two beeps for FCC mode, then goes yellow.

Anybody had this problem yet? Flew fine last night, then powered up this afternoon and got a message that said my transmitter needed recalibration. Loaded up the phantom to the Assistant software on my Mac and did the recalibration. Didn't seem to work. Looked at DJI Wiki and followed the steps...

I too had problems with the USB port on Virtual Box, but after I plugged it into one of the other USB ports it worked fine. Just seemed to have problems with one of them.

Looks like the Phantom is flying in GPS mode and being buffeted by winds and trying to hold its position. If you haven't already, upgrade the firmware and turn on the advanced flying features in the software. You then should be able to toggle back and forth between GPS mode and ATT mode. ATT...

Try rebinding. Page 14 or so in the manual.

I was having this same problem too. I went through a rebinding process between the wifi extender and the Phantom and everything works great. Look in the downloaded manual for the Phantom Vision. I believe it is on page 14 or 15. Try that and see if it helps.

I was having this same problem too. I went through a rebinding process between the wifi extender and the Phantom and everything works great. Look in the downloaded manual for the Phantom Vision. I believe it is on page 14 or 15. Try that and see if it helps.

Just unbowed my Phantom Vision 2. Same thing is happening to me.

I'm having the same issue. All systems go except the DJI Vision app won't connect to the camera. Says : Connect to Phantom Vision 2 Failed.