Recent content by pixelvandal

ok, so after pulling the battery out, reinstalling dji go, and relinking the aircraft and controller and phone, im able to connect again. i am able to do an IMU calibration, and I am able to calibrate the compass. i am able to take off, and i am able to fly. It will still not update, no matter...

not sure what mistake i could have made? there are 3 connections when hooking up the replacement gimbal, the two antenna(i think thats what they are, small round pop on/off connector) and the white plug. i took a photo and replaced all 3 cables as per the original. sigh, how frustrating. Thanks...

RodPad! thank you for your quick reply :) the gimbal does not move whatsoever, but the light on the side of the gimbal does. Resyncing the aircraft to Rc is successful, green lights on both (however still N/A in version number) plugging usb into gumbal definitely does nothing at all, tried on 2...

oh, and also, if i plug my usb cable into both the gimble or the aircraft, i get nothing come up on my windows 10 Pc....

and i realize that the aircraft version is super old.... haha. i bought it from a friend who had never bothered with updates or anything, and since it worked.... i just flew it.

Hello all, Sorry to make this my first post. backstory - i had a P3S, flew it, all good, loved it. crashed it. snapped an arm off the gimble (oops) and tore the ribbon cable off. Drone was still able to fly just with no vision, no big deal. saw a used gimble + camera assembly online - purchased...