Recent content by oldvettedrvr

I have a NAZA Lite that won't arm, everything on it works but it won't arm. all tests and features work even the motor test works. I have tried exchanging it with a working setup and it still won't arm. Could this be a software problem or something more serious??? Thanks, Julian

I am not sure if my fix will work for you but worth a try. I had replaced the camera gimbal cable with a cheap one,,,I was having intermittent problems with the camera so I bought a DJI gimbal cable and the first time I powered it on it went right to the Activation Screen.. Good Luck, Julian

Found one locally, Thanks

I am looking for a P3P mainboard, nonworking for parts only. Thanks,,,,

Brand new shell,, has no electronics installed when this occured

I used the stuff preapplied to the screws. They were just barely snug,,no where near tight

I have some of the stuff.. my contention is that they should not crack just from mounting the motor!!!

I am trying to rebuild a P3P that was crashed and I had to replace the shell. New motors came in yesterday and I managed to get two installed before I had to quit for the day. When I went out this AM I noticed a CRACK between two screw holes on both motors! These motors have never been run or...

I replaced the main board in my P3P and the DJIgo app is telling me to "Activate Aircraft". I cannot get the DJIgo to go to an activation screen. When I first installed and ran it for the first time(with original board) it did not ask to activate and it would arm so I assume the old board had...

I am interested in gear if Lightbridge antenna are included. OR antennas by themself

I am in need of one Lightbridge antenna. The one with #2 stamped on it.. Hoping someone has one for sale so I don't have to buy a whole set. Thanks, Julian

Update... I am thinking I have a bad or loose cable. Now everytime I turn it on it does something different. The only thing consistent is video dropping in and out. The HD Ch monitor only shows blips of green and or red. I am assuming that the bars should go up quite a ways. Can someone please...

Nope, only the one that came with it..

I have a P3P that has been repaired from a crash. Replaced gimbal cable, gimbal arm and battery tray. When I power it up, I get the Gimbal startup "wiggle" and it works fine, It will stay level as I tilt the AC around and I can control the tilt from the controller. I have left it on for probably...

Yeah I did!!! Thanks,,