Recent content by nparker76

Well still no luck after reinstalling the app. I'm gonna trying taking the new ribbon cable back off and reinstalling just to make sure all the contacts are good. Not sure what else to try.

I bought and installed a new ribbon cable. I got a DJI version and not a cheap knockoff. I'll try to reinstall the app and login again...maybe get to it tomorrow.

I wouldn't think that the antenna cables or the little discs on the end would go bad, but I see replacements so I assume they can. Should I try and replace those? I'm kinda at a loss now. I've tried everything I can think of and I've read lots and lots of posts. I'd much rather repair myself...

I triple checked the black and grey antenna wires. I checked the big square pads where they are mounted and look fine...and I checked where they are connected on the board by the gimbal. I also tried relinking again and it just times out. Any other ideas?

Thanks for the direction. I'll check those wires sometime this weekend.

Yeah I'm familiar with those. I've taken them off and on several times, at least where they connect to the gimbal. Before I messed with it I marked the black location with a sharpie so I wouldn't install them backwards. I'm pretty sure they are connected correctly at the gimbal. Is there...

No I don't receive any of that info. And I tried relinking and it just beeps until it times out.

I had a small crash and the gimbal was flopping about afterwards at startup. I went ahead and swapped out the flat flex cable and made sure all the motors were aligned properly. The camera and gimbal seemed to act right on start up initialization. The AC link light is green. The camera light is...

Did you ever get it fixed?? I think I'm having the same problem and can't find anything that works. I had a small crash. The gimbal was flopping about afterwards. I went ahead and swapped out the flat flex cable and made sure all the motors were aligned properly. The camera a gimbal seem to act...