Recent content by Neville Stanikk

My Phantom 3 is running on a 7" iPad Mini, which is fine and is what was handy at the time but really I want it to run on a 10" iPad. How do I change from one to the other ? DJI GO is installed on both so any advice would be gratefully received.

In the DJI GO camera settings for the still camera there's ISO, Shutter and then at the bottom, M.M. Does anyone know what M.M stands for ? It changes when the toggle the other two but I'm not quite sure what it's indicating.

I'm doing it in a conservatory

I'n NOT hurrying, I'm watching tutorials and reading the manual but things are not happening as they say they should.

Don't worry. There'll be no taking off yet ! I AM watching tutorials and as far as I've got is turning the aircraft on. It's connected to the RC and I assumed it would do its 30 second self check but it continues to flash and beep. The app told me that the RC firmware needing upgrading so I did...

I got the remote controller to turn off. Thank you. Bit later So now the remote controller can see the camera picture but the aircraft is still beeping. It says it needs its compass orientating but I've stood 1.5 metres away, away from any interference and turned the around around 360 degrees...

Tried that. Still on. And while I've got you, so to speak, how long should the self check take ? It's been over five minutes now and it's still flashing and beeping

New pilot, just beginning. How do I turn off the remote controller ? I've held the button down (for short and long periods) but that does nothing.