Recent content by Martin Sondergaard

I will try

It will not connect before i am 20 meters away from the drone - in DK - CE requirement do, that this is not use because of it weak signal

Thanks...

I have the same firmware 1.4.1.0

drone: rev 01.05.0600 Rc(gl300e - build in screen): 01.04.01.00

Thanks Status: Went out side - no change Have factory reset both drone and rc and upgrade them to newest version - no change Hope somebody have the magi solution

Thanks for answer - but I didn’t have the issue/errors 1 hour earlier before the factory reset I will I effect the green pixels?

Hi, I had some problems with my P4P+ on my vacation - the DJI GO4 stop working and rebooted it self - I was advice in the forum to reset my RC(GL300E - build in screen) Today I reset the the RC to factory spec and re-install firmware and DJI GO4 app. And now i really have problems... First...

Hi, Earlier I posted that the DJI GO4 was crashing under flight and the problems with pixels(the pixels was lacking)on my screen(build-in screen) I went out this morning to fly and the same happened - I noticed that controller was very hot on underside/backside of the controller, is that...

Hi, Thanks, for all your answers, so I will not worried that much, I was taken by surprise... To the Danish guy: The drone was only 100 meters away and yes I think the is DJI GO4 there cause the problem Br. Martin

Hi, First - Sorry for my English(I am Danish) I went out flying this morgen, and suddenly this error came up: " unfortunately, DJI GO 4 has Stopped" I nearly lost the drone but RTH bottom worked - second later the GO 4 worked again. I am flying Phantom 4 PRO plus, so I know it’s not a tablet...