Recent content by MAD2

I just tried to help. I did not see or read anything about as fast as possible. I will certainly never try to help you again LOL

Flex Camera Gimbal Flat Cable Repairing Wire Replacement Ribbon for DJI Phantom 3 SE Version-in Drone Cables from Consumer Electronics on Aliexpress.com | Alibaba Group

I think its time you make a video of your problem and post it on Youtube You will be surprise with the feedback. Let me know once the video has been posted please.

Hope some of these suggestions will help you Good Luck

Will also help you with pairing your controller to your drone again Reset controller and drone pairing Pull Gimbal control Scroller left all the way for 2 seconds then Flip S2 Switch to front and back 4 times Controller begin to beep Then on right side of drone push reset button for 3...

If the light will flicker between green and red That means your WiFi has been reset successfully Well done Turn your receiver off and on again and pair with the Dji apps with the password 12341234

Switch 2 This is the Left Switch Reset WiFi Password to factory defaults Roll Gimbal adjuster all the way to the right Flip S2 Key up and down for a few times while holding the gimbal adjuster Until the power button on your gimbal turns to red. Turn Remote controller off and on again and...

Thanks Nightwolf

Nightwolf thanx i just found out there is another way to get it working. I have to calibrate the gimbal every time before i fly.

Hallo all I bought a secondhand unit that were in a crash Everything is working fine, except if i start the quadcopter i must press the gimbal lightly down about 45% before the controller button works. That is now the scroll wheel for tilting the gimbal up and down. Thanx for the help in advance.