Recent content by Mad Ox

  1. Mad Ox

    Birdside antenna mod version 2.0.

    Over the course of several days, I DID read the entire thread... The wires attached to antennas on the legs run directly to the board inside the AC. It would seem obvious that the new P3P antennas could do the same- unplug the P3S antennas, replace them with the P3P antennas. No wires hanging...
  2. Mad Ox

    Birdside antenna mod version 2.0.

    I have a P3S and and did the DBS mod. I also replaced the stock P3S birdside antennas and the landing gear with a set from a P3P as was mentioned earlier in this thread. Instead of just running the antenna wires straight to the camera, I opened the AC and and removed the stock antenna wires from...
  3. Mad Ox

    Payload Drop With Servo

    First post, though I've been around for a while... It seems that a better idea than a servo would be a push/pull solenoid. In this case, a pull solenoid would fit the bill. Solenoids are available in a variety of sizes/power configurations and should be able to be tied into the Phantom's on/off...