Recent content by LuckyP3P

I am sorry for your lost too.

Thanks. I saw that there some pads near the motor drive. I found that they are for diagnosis but I haven't found the values. When I have time I will try to compare the values between M3 and M1 values. In the meantime I'm looking for a ESC center board [emoji5]

Hi quaddamage, yesterday I had time to check the M3 esc error. I have followed the flow chart and I checked the resistance of every pair of M3 motor wires and they are 0,08 Ohms. The M1 has same values. I'm sorry but I could not measure inductance. Then I tested the resistance between battery...

Ok! It is already great to have limited the area where the problem may be. I will start to test the motor, I notice it is a bit harder to rotate than the other. I will tell you the values I will measure. Thanks

Hi quaddamage, thanks a lot for your advices. I have started the diagnosis for the "ESC Status Error" and in the .DAT file I have found in the column "esc3_status" the value 18 and in all the other esc3 columns only the value 0, while in the other "escX_status" (X=1,2,4) I have found the 0 value...

Thank you very much Quaddamage.

Thanks Meta4. I know it, for this reason I used also isopropyl alcohol to eliminate all salt residues. I'm not able to make a diagnosis of what can be broken and I would like to avoid changing parts at random.

Hi everyone, my P3P fell into sea water, I immediately recovered and washed it in fresh water. The battery is gone, while the drone, after being dried for 3 days, turns on but has the following problems: - no images in the app; - the camera controls don't work; - the micro SD isn't recognized; -...