Recent content by kwhi02

Great thanks - exactly that. I drove out into the countryside and calibrated the compass away from me phone. Seems great now, dead centred in the immediate tests. I'm amazed Litchi didn't suggest this after emailing them several times.

Update here: I've bought a P4P and it does allow actions on the first and last points of curved missions, provided the mission has more than two waypoints in total.

Update: Litchi responded saying: Hi, A new home location is valid only if it is within 30 meters of the drone or you. Kind Regards, Litchi Which is partially correct, I've tested using my P4P and you can move the home point to within 30 metres of the drone location but no the controller...

I own two drones, a P3S and a P4P. Running the identical mission on both; the P3S reliably keeps the POI pretty much dead centre whilst the P4P for some reason keeps the POI pretty much on the thirds to the left. Anyone else found this? The P4P is using latest firmware and all software is up to...

FYI - I've just purchased a P4P and installed all the latest OS and Firmware. I tried moving the home point and encountered exactly the same problem. @dwallersv - I appreciate the time you spent writing the response to my question however i'm guessing you didn't test it out yourself to see if...

Great thanks - for anyone searching this: [email protected]

Thanks for this - I check out versions. Out of interest how do you contact Litchi support? I've not found a way yet.

I can't find the 'Narrow sensing (hold)' option in Litchi wondered if I was just not looking in the right place or if there is another way to temporarily disable the sensors? Flying P4P using latest version of Litchi

Thanks, just tested this and you're right. Previously the drone was close by when testing so displayed 'Landing' rather than RTH. I repeated and flew the drone away a bit further and it worked fine. Thanks

I understand why it's not possible to have actions on waypoints in curved missions. That being said there is no reason why actions don't work at the first and last waypoints. Would be great if Litchi introduced this.

Yeah definitely landing where it is rather than RTH. To clarify, the problem is there is no way in Litchi to activate RTH. RTH works fine when the battery is flat or using the DJI Go App. The P3S unlike my P4P doesn't have an RTH button on the remote and there is nowhere in the app to activate...

You can specify 'signal lost behaviour' and set to RTH but you can't make it RTH as far as I can see.

Thanks for this - I'm pretty sure when I do this is just lands rather than RTH, but will test again. Cheers

Anyone know how you can activate RTH using a Litchi and the P3 Standard?

I've created and tested mission with every variety of settings I can thing of, Focus POI, Interpolate, curved, straight, with signal the whole time, without signal. Best I can figure out is sometimes the gimbal does what it's told other times it doesn't. Something like 60/40 fail. I'm using...